[#covidDesign] BIT SCREWDRIVER

Simple screwdriver for a 1/4″ bits. I designed a 5×2,5 mm gap for a small magnet. It is not mandatory, but may be usefull if yours bits are too loose. Simply use Pause at height/layer option in slicer software and put magnet while printing.

Pause for magnet

Printing setup

Filament PETG or similar, no supports. Raft or brim: maybe. Depends bed adhesion.

BIT SCREWDRIVER #covidDesign

Version: 1
Published: 5 April 2020
     

Please consider SUBSCRIBE for a new posts. Just clik the bell on bottom left side. Thanks!
Subscribe
Notify of
guest
2 Comments
Oldest
Newest Most Voted
Inline Feedbacks
View all comments
Donald Shelby
Donald Shelby
1 year ago

esrdt